The first paragraph of scope as below:IEC 60335-1:2020 content:This International Standard deals with the safety of electrical appliances for household and similar purposes, their rated voltage being not more than 250 V for single-phase appliances and 480 V for other appliances including direct current (DC) supplied appliances and battery-operated appliances.IEC 60335-1:2010+A1:2013+A2:2016 Version 5.2 including Version…
The ninth paragraph of introduction as below:An appliance employing materials or having forms of construction differing from those detailed in the requirements of this standard may be examined and tested according to the intent of the requirements and, if found to be substantially equivalent, may be considered to comply with the standard. Since the standard…
The eighth paragraph of introduction as below:An appliance that complies with the text of this standard will not necessarily be considered to comply with the safety principles of the standard if, when examined and tested, it is found to have other features which impair the level of safety covered by these requirements. Although the product…
The seventh paragraph of introduction as below:Individual countries may wish to consider the application of the standard, as far as is reasonable, to appliances not mentioned in a part 2, and to appliances designed on new principles. In this case consideration should be given to defining normal operation, specifying the classification of the appliance according…
The fifth paragraph of introduction as below:When a part 2 standard does not include additional requirements to cover hazards dealt with in Part 1, Part 1 applies.NOTE 2 This means that the technical committees responsible for the part 2 standards have determined that it is not necessary to specify particular requirements for the appliance in…
The fourth paragraph of introduction as below:If the functions of an appliance are covered by different parts 2 of IEC 60335, the relevant part 2 is applied to each function separately, as far as is reasonable. If applicable, the influence of one function on the other is taken into account.NOTE 1 Throughout this publication, when…
The third paragraph of introduction as below:This standard takes into account the requirements of IEC 60364 as far as possible so that there is compatibility with the wiring rules when the appliance is connected to the supply mains. However, national wiring rules may differ. IEC 60364-1 Low-voltage electrical installations – Part 1: Fundamental principles, assessment…
Clause 8.1.1 mentions that the test probe should be used when the appliance is under “normal use”, while clause 8.1.5 is evaluated prior to installation. Products such as these, which are delivered in several parts, generally require on-site installation. “Live parts of built-in appliances, fixed appliances and appliances delivered in separate units, shall be protected at least by basic insulation before installation or assembly.” Here a type of hazard during installation arises. An example is as follows: An air-conditioning…
standard give us a formula as below: the key requirement in note: The resistance of windings at the end of the test can be determined by taking resistance measurements as soon as possible after switching off and then at short intervals so that a curve of resistance against time can be plotted for ascertaining the…
You cannot copy content of this page